If you want to know how to adjust the steering wheel in your Toyota 4Runner, follow these simple steps. First, remove the screws that hold the plastic housing to the steering column.
Next, unscrew two bolts at the bottom of the column. You will see the adjusting lever on the right side of the column. You can turn the lever until you find the desired position. Then, engage the adjusting lever by turning it 2.5 turns in each direction.
Now, take your hands and carefully unbolt the steering wheel from the column.
You’ll need to use two hands to remove it, and then you’ll need to use a wrench or pliers to loosen the nut on the steering column.
You may want to use a slight wiggle to get the wheel out. The video below will show you how to unscrew the nut on the column.
This will help the steering wheels slide on the splines. This is an important safety precaution because it could lead to serious injury.
Now, you can remove the top and bottom cover of the steering column. Using a pry tool, loosen the lever and lift off the top and bottom cover of the column.
The plastic cover on the cruise control can also be removed using a pry tool. Then, use the pry tool to remove the plastic cover on the airbag and cruise control. The airbag is held onto the steering wheel with two Torx screws.
How do I center my steering wheel?
Centering a steering wheel is a complicated process that can be confusing. There are two primary reasons for this. First, a crooked wheel is an indicator that the wheel is not centered. The second reason is the presence of a misaligned rear axle.
A misaligned rear axle will cause the steering wheels to be off center. In both cases, the solution to centering a steering column is to install a centering kit.
While steering wheel centered with a jack is a relatively easy task, a poor result may lead to deeper problems. Most steering wheel misalignment problems are caused by a twisted tie rod.
Fortunately, the solution is simple and effective – you only need the right tools and the right technique!
To center a steering column, you must jack up your vehicle and remove the seat.
After removing the floor mat and removing the center console, you can turn the steering column back and forth in order to realign the tie rods with the wheels. Be sure to tighten the tie rods afterward.
One of the most frustrating things when driving a car is an off-center steering wheel. It can be difficult to drive straight and can cause you to overcompensate to compensate.
Fortunately, the solution is relatively easy and will save you a lot of time and frustration. A properly-centred steering column is the first step toward fixing your car’s alignment problems. In order to fix your wheel’s position, you must first determine where it is off-center.