The Hub Nut on a Dodge Ram 2500 is one and a half inches. It’s the nut that holds the wheel hub to the axle. To remove it, you’ll need an impact driver and a special socket.
This nut is not designed to be removed with a conventional wrench, but requires more torque to keep it in place. If you have a tool like this, you can buy it at a car-parts store and use it to remove it.
The Dodge Ram 2500 has a 36-mm axle bolt and 18mm hub bolts. To remove them, you’ll need a sledge and a wrench with a stud-mounted tire lug and a socket with a one-inch or one-half-inch hex drive. Make sure to use a socket with a hexagon-shaped wrench for this process, otherwise you’ll have trouble.
The Dodge Ram 2500’s front axle nut is a 36-mm bolt. To replace it, you’ll need to install new wheels, lugs, and hub nuts. The wheels need to be able to sit on the axle without coming loose.
Loose axle nuts can damage the axle and the wheel bearings, so it’s important to secure the wheel and axle nut properly. To save money, you can do it yourself.
What size is the axle nut on a 2001 Dodge Ram 2500 4×4?
The size of the axle nut on a 2001 Dodge RAM 2500 4×4 is S3/16 ” to 3/18″ in diameter.
The nut is secured to the hub with a cotter pin and axle-ring retainer.
If the retaining ring or cotter pin is damaged, the wheel will wobble.
This can damage the bearings, races, spindle, and other components. It can also cause low grumbling noises.
The nut for the rear axle on the 2001 Dodge Ram 2500 4×4 is a Dana 80.
The sockets for this nut are 14mm. In addition, the hub should be attached with three bolts. In general, the rear axle nut size is a Dana 80. The nut size is important because it determines how much torque you have.
A common question, “What size is the axle nut on a 2002 Dodge Ram 2500 4×4?” Is “What size is the axle nut on my truck?”.
Fortunately, the answers to these questions are easy to find. All you need is a set of sockets and a few minutes of work. You can also visit your local auto parts store and find a repair shop.
What size is the axle nut on a 2013 Ram 2500?
If you are having trouble with the brakes on your Ram 2500, you need to replace the front axle nut. You can buy a replacement part from an automotive specialty store.
It is one and eleven-sixteen inches in diameter and can be removed using an impact driver. Alternatively, you can also buy a socket and use it to remove the old rusted axle nut.
A 13 Ram 2500’s front axle nut is a 42-mm nut. It is important to avoid over tightening lug nuts, as these will begin to spin in the socket.
If you are unsure of what size your lug nuts are, you can use a mechanical press to remove them.
If your lug nuts have snapped, you will need to remove the rotor first before attempting to remove the nut.
For any other questions or concerns, please post them in the “General Discussion” sub-section.
The best place for non-technical discussions is the “General discussion” or ‘NON-tech’ sub-sections.
However, if you cannot find a suitable answer, feel free to ask your local mechanic.
You can ask them to help you find the right solution for your needs.